KROHNE C95 CI EN - Manual (Page 7)

S
4.3 M Main m menu
If code correct,
access to pro-
gramming
menu
Analog
output
simulation
Authorized by
access code
Erasing of
recorded
alarms
rEAd ProG
CodE
88888
GEnE. CLEAr
« «
«
« «
Access code
programming
Display
simulation
instant or
cumulated
value, accor-
ding to type
of display
present befo-
re the access
to the menu
Authorized by
access code
(relay /analog
output) (analog
output)
(relay output)
P.CodE SIMUL
« «
Tare zero
reset
Authorized by
access code
CLr.tA
«
menu
scroll vertical
move
Entering of the access code.
The access to the programming
menu is protected by a 5-cipher
code.
The code on factory exit is 00000
(to change this code, see p20 ).
Configuration
reading
mode
M M
4.4 P Programming m menu
(according to options)
dISPL.
totAl.
OUt.MA
JbuS
tor
rELAY
SECU
Pr.diS
SAvE
SAvE
Access to input programming p7
Access to the display factor programming p7
(instant value)
After programming the totalizer p8
Access to the analog output programming p8
(option analog output)
Access to the communication parameters p9
(option digital output)
Access to the programming of the LOGIC inputs p9
(option LOGIC inputs)
Access to the programming of the relays (2 relays) p10
(option relay output)
Access to the programming of the output, the relays, p11
in case of self-diagnosis and/or sensor rupture, and
access to disconnecting the sensor rupture
(option analog output or relays)
Access to the display programming : p12
Bargraph, display brightness
Access to the programming exit menu with or p13
without configuration saving
Note :
⇒ Press to reach menu
⇒ In mode programming, the instrument will automatically resume measur-
ing with the former configuration if no key is pressed during 1min.
Move through menus / choice
InPut
Downwards move /
decrease
Validation / Vertical move
Menu exit / access
Upwards move / increase M M