KROHNE C95 CI EN - Manual (Page 24)

S
5.2.2 Tare setting (only on instant value display)
Press and to enforce the signal present on the input as display
down scale
Note : The tare is not recorded in case of power supply cut.
To suppress the tare, go into menu in the main menu p6.
Exit from mode programming with configuration saving will automatically
reset the tare to zero.
(accessible according to programmed access code)
d.dISP
CLr.tA
5.2.4 Direct measure visualising
Press and to visualise the signal directly without any processing
: scale factor, square root, linearisation
− in mV, V or mA.
M M
5.2.3 Changing of the displayed value
Press and to switch from the instant value to the totalizer, and
vice-versa.
Led marking A blinking : instant value.
Led marking H blinking : totalizer
5.2.5 Visualisation and setting of alarm setpoints
Setting of setpoints : There are 2 ways to adjust setpoints.
- either in mode programming entering the correct safety access code
- or by simultaneous pressing on and
M M M M
Option 22 rrelays
M M M M
The meter will then show the message SP.x or SPx.x alternating with
the value of the corresponding setpoint.
The various setpoint values can be accessed by or .
These setpoints can then be changed (according to the programmed
access code, see p20) pressing
Once the setpoint is adjusted, press to revert to the setpoints rea-
ding menu.
Once all setpoints are adjusted, just press and the meter will revert
to mode measure, taking the new values into account.
If no key is pressed during 60 s., the meter will revert to measure
display without taking the modifications of setpoint values into account.
66.. E ER RR RO OR R oorr iinnddiiccaattiioonn M ME ES SS SA AG GE ES S
2000
OPEn
Err.1
Value in overstepping
Sensor rupture
«
01000 Counting overstepping
> 999 999 999
or < -99 999 999
«
----
O.L.
Er.xxx
Input upper or lower electrical
overstepping
Displayable value overstep-
ping.
Self-diagnosis error
Value set out of range
On instant value display
On totalizer display
totalizer
OPEN -----
Electrical overstepping or
sensor rupture recorded. or