KROHNE C95 CI EN - Manual (Page 23)

S
c / Deleting of maximum and minimum values
M M
CLr.M
Measure
display
revert to measure display.
Reminder : If no key is pressed during 20 s.,
the instrument will revert to measure display.
Note : Exit from mode programming with configuration saving
will reset min. and max. values to zero
Deleting of recorded min. and
max., and revert to measure
display
5.1.1 On the totalizer display
a) Totalizer upper part display
Hi.tot
0010
Totalizer
display
number of overteppings on the
totalizer
The cumulated value is :
Hi.tot x 1 000 000 + totalizer value if totalizer ≥ 0
and Hi.tot x -100 000 + totalizer value if totalizer < 0
b) Access to the totalizer zero reset menu
rdEP
r.totA
Totalizer
display
Zero reset of error
recordings
Zero reset of the
totalizer, Hi.tot and
of error recordings
Access only if user code
<30 000
5.2 FFunctions w which rrequire ppressing sseveral kkeys :
5.2.1 Display shifting (only on the instant value display)
(accessible according to programmed access code)
M M
Display down scale shifting (AdJ.Lo)
Display full scale shifting (AdJ.Hi)
After injecting an input signal corresponding to the down (or full) display
scale, press simultaneously on keys and (or and ) The
message AdJ.Lo (AdJ.Hi) will appear alternating with the value, to indi-
cate you are in menu adjustment.
The display down and full scale can be increased or decreased by pres-
sing or .
Keep pressing during 3s. on key or to access a fast increasing or
decreasing of the display value.
Press to validate the shifting. Once all shiftings are validated, the
input thus shifted will keep its shifting even after a setting off tension.
Press (or do not press any key during 20 s) to revert to the
measure display without modifications.
M M
M M