KROHNE C95 CI EN User Manual
Page 22
S
GEnE.
GEnE.
Output value
if
Enter value to
be injected
M
M
Pressing menu
reverts to
measure
display.
Note : The instrument carries on measuring during the simulation.
Only the analog output no longer reacts to measure.
CLEAr
4.10.3 Menu
: Erasing of recorded alarms
If the function recording of alarms has been programmed, the relay
state will be recorded after a setpoint has been passed.
If the setpoint is passed back the other way, the relay state does not
change and the corresponding led starts to blink.
To come back to the normal state (led not blinking and relay in the cor-
rect state) use menu CLEAr.
M
M
CLEAr
recorded alarms are not
erased
erasing of recorded
alarms, and revert to
measure display
Reminder : If no key is pressed during 20 s.,
the instrument will revert to measure display.
Note : Exit from mode programming with configuration saving will reset
alarm recordings to zero.
(accessible according to programmed access
code and if option analog output)
4.10.2 Analog output simulation (mode generator)
CLr.tA
4.10.4 Menu
: Deleting of the programmed tare
M
M
CLr.tA
the recorded tare is not
suppressed
deleting of the recorded
tare, and revert to meas-
ure display
Reminder : If no key is pressed during 20 s. , the instrument will
automatically revert to measure display.
Note : Exit from mode programming with configuration saving will
reset the tare to zero.
(accessible according to programmed access
code)
5.1 FFunctions w
which rrequire ppressing oonly 11 kkey :
5.1.1 On instant value display
a / min. value display
b/ Max. value display
InF.
02.00
Measure
display
Alternate infor-
mation display
Minimum value
55.. FFU
UN
NC
CT
TIIO
ON
NS
S A
AC
CC
CE
ES
SS
SIIB
BLLE
E D
DIIR
RE
EC
CT
TLLY
Y FFR
RO
OM
M
D
DIIS
SP
PLLA
AY
Y
SUP.
08.00
Measure
display
Alternate informa-
tion display
Maximum value
Note : The instrument does not measure during the simulation. The ana-
log outputs, the alarm, the pulse outputs and the bargraph will react
according to the value entered for simulation purpose.
The totalizer stops during the simulation. It is saved, and will then be
restored.
If alarm messages have been programmed, they may appear during the
simulation.