KROHNE C95 CI EN - Manual (Page 27)

S
Output on the instant value
Output on the cumulated value
Analog output down scale
Analog output full scale
Access to programming of the display for output down scale
Access to programming of the display for output full scale
d.out
F.out
InStA
totAL
dO.diS
FO.diS
19200
dELAY
Digital output
Access to the RS output programming sub-menu
Slave number
Transmission speed (baud rate)
Possible speeds
Possible speeds
Time delay before any response
Delay 75ms Delay 20ms
bAud
SLAuE
1200
JbuS
OFF On
Setpoint value in mode setpoint
1st setpoint value in mode window
2nd setpoint value in mode window
Hysteresis value in display points
Time delay on relay X
SPx.1
SPx.2
HYSt.x
tiME.x
SPx
Relay outputs : x : 1 à 2
Access to the relay outputs programming sub-menu
Access to the programming of relay x
Activation of relay output 1
Activation De-activation
Relay operating mode
Mode alarm
Mode pulses
Parameter applied to the alarm
Alarm on the instant value
Alarm on the cumulated value
Relay x operating mode
Mode setpoints
Mode window
OFF
ModE.x
__1--
--1__
ActiX
tYPE.X
PArA.X
ALArM
PuLSE
inStA
totAL
rEL.x
On
rELAY
_1--1_ -1__1-
Programming of the relay associated led
Led lit when relay active (coil supplied)
Led still when relay active (coil supplied)
Recording of alarm X
Recording No recording
Alarm message
Message No message
Pulse weight
LEdx
On
OFF
MEM.x
MESSx
P.rAt
no YES
no YES
Pulse duration
100 ms
200 ms
400 ms
P.time
100
200
400
rEL.X
OFF
rUPt
CAPt.
OFF
LO
H I
SECU
Safeties
Access to the safeties programming sub-menu
Programming of the sensor rupture safety
Sensor rupture activation (or not)
De-activated Active
State of relay X in case of sensor rupture
No sensor rupture associated with the relay
Relay de-activated in case of sensor rupture
(coil not supplied)
Relay active in case of sensor rupture
(coil supplied)
On