KROHNE OPTISENS OAM 2080 EN - Manual (Page 19)

ELECTRICAL CONNECTIONS
4
19
OPTISENS OAM 2080
www.krohne.com 08/2010 - MA OPTISENS OAM 2080 R01 en
Electrical connections
4.1 Safety instructions
4.2 Cable connections
In the bottom lower left corner of the enclosure there are four ½" NPT female electrical
connections as cable feedthroughs to the junction box. All cables fixed on the terminal blocks go
outside the enclosure via these connections.
Right beside the ½" NPT female electrical connections there is 5-pos. M12 female connector (A-
coded). This connector is wired internally and dedicated for a tailored cable with the
corresponding male connector that belongs to the scope of delivery.
DANGER!
All work on the electrical connections may only be carried out with the power disconnected. Take
note of the voltage data on the nameplate!
DANGER!
Observe the national regulations for electrical installations!
WARNING!
Observe without fail the local occupational health and safety regulations. Any work done on the
electrical components of the measuring device may only be carried out by properly trained
specialists.
INFORMATION!
Look at the device nameplate to ensure that the device is delivered according to your order.
Check for the correct supply voltage printed on the nameplate.
INFORMATION!
The connection cable with in the scope of delivery has 5-pos. M12 male connectors (A-coded) on
both ends. Both male connectors fit to the female connector on the converter as well as to the
connector on the bottom of the enclosure.
1 Manual hauling switch
2 Left terminal block
3 Right terminal block
4 5-pos. M12 female connector (A-coded)
5 ½" NPT female connector
6 Safety switch
.book Page 19 Friday, August 20, 2010 1:07 PM