KROHNE IFC 300 Converter FOUNDATION FIELDBUS EN - Manual (Page 36)

4
OPERATION
36
IFC 300
www.krohne.com 02/2011 - 4001086501 - AD IFC 300 FF R02 en
4.7 Integrator Block (IT)
The following tables list the 2 Integrator Block parameters in alphabetical order.
It describes characteristics of the signal converter measurements for forward (positive) and
reverse (negative) flow at the same time. Both integrators were intended to totalize the forward
flow Integrator 1 (+ Flow Totalizer) on the one hand and the reverse flow Integrator 2 (- Flow
Totalizer) on the other. The configuration of these blocks is almost the same, unless stated
differently.
The following tables contain short parameter description, factory settings (Initial Value (IV)) and
possible settings.
Parameter Parameter Parameter Parameter
Subelement Access Description and settings Initial Value
Alert Key Alert Key Alert Key Alert Key R/W The identification number of the plant unit. This information
may be used in the host for sorting alarms, etc.
0
Setting:
0...255
BLOCK_ERR BLOCK_ERR BLOCK_ERR BLOCK_ERR
Block Error Block Error Block Error Block Error
R This parameter reflects the error status associated with the
hardware or software components associated with a block. It
is a bit string, so that multiple errors may be shown.
Actual measured
value
Setting:
• Other: Non-specific error active
• Block Configuration: Error detected in block configuration
• Simulation Active: Simulation enabled in this block
• Local Override: Output tracking of faultstate active
• Device Fault State: Device faultstate set
• Device Maintenance: Device needs maintenance soon
• Input Failure: Process variable has bad status
• Output Failure: Failure detected in output hardware
• Memory Failure: Memory error detected
• Lost Static Data: Static parameters cannot be recovered
• Lost NV Data: Non-volatile parameters cannot be recovered
• Readback Check: Failure detected in READBACK
• Maintenance Needed: Device NEEDS maintenance NOW
• Power Up: Recovery from power failure
• Out Of Service: Block actual mode is out of service
MODE_BLK MODE_BLK MODE_BLK MODE_BLK
Block Mode Block Mode Block Mode Block Mode
Mix The actual, target, permitted and normal modes of the block. -
TARGET
Target
R/W By setting this parameter to an allowed value (one of the value
from permitted modes) user can change the block execution
mode. Changing of modes is required to change the access
permissions available to various parameters.
OOS
Setting:
Auto / Manual / OOS
ACTUAL
Actual
R This is the current mode of the block, which may differ from
the target based on operating conditions. Its value is
calculated as part of block execution.
Factory Settings
PERMITTED
Permitted
R/W This parameter defines allowed modes for this function block
and can be set by user.
Auto, Manual or
OOS
Setting:
Auto / Manual / OOS
.book Page 36 Tuesday, January 18, 2011 3:40 PM