KROHNE IFC 300 Converter FOUNDATION FIELDBUS EN - Manual (Page 20)

4
OPERATION
20
IFC 300
www.krohne.com 02/2011 - 4001086501 - AD IFC 300 FF R02 en
DIAGNOSIS_DEV DIAGNOSIS_DEV DIAGNOSIS_DEV DIAGNOSIS_DEV
Diagnosis Device Diagnosis Device Diagnosis Device Diagnosis Device
R Display of maximum 8 (error) messages. Current diagnosis
Setting:
0:Startup phase / 255:no message
F: F: F: F: error in device / IO 1 / parameter / IO 2 / configuration /
display / sensor electronics / sensor global / sensor local /
field current local / current output A / current output B /
current output C / software user interface / hardware
settings / hardware detection / RAM/ROM error IO 1 /
RAM/ROM error IO 2 / fieldbus / application error sensor /
empty pipe / flow exceeding limit / field frequency too high /
DC offset / open circuit A / open circuit B / open circuit C /
over range A (current) / over range B (current) / over range C
(current) / over range A (pulse) / over range B (pulse) / over
range D (pulse) / over range display 1 / over range display 2 /
active settings / factory settings / backup 1 settings / backup 2
settings
S: S: S: S: out of specification / uncertain measurement / pipe not
full / empty pipe / linearity / flow profile / electrode noise /
gain error / electrode symmetry / field coil broken / field coil
bridged / field current deviation / field frequency too high /
electronic temperature / field coil temperature / overflow
counter 1 -FB2 / overflow counter 2 -FB3 / backplane invalid /
overflow counter 1 / overflow counter 3 -FB4 / checks in
progress
C: C: C: C: test sensor / simulation fieldbus
I: I: I: I: counter 1 stopped-FB2 / counter 2 stopped-FB3 / power
fail / counter 1 stopped / counter 3 stopped-FB4 / power fail /
control input A active / control input B active / over range
display 1 / over range display 2 / backplane sensor /
backplane settings / backplane difference / optical interface /
write cycles overfl. / baudrate search / no data exchange /
conductivity off / diagnosis channel off / empty pipe
Current diagnosis
DISPLAY_CNFG DISPLAY_CNFG DISPLAY_CNFG DISPLAY_CNFG
Display Configuration Display Configuration Display Configuration Display Configuration
R/W Select the function block output value to display at which line.
For details see subelements.
-
DISP_LINE1
Display Line 1
Setting:
AI1 / AI2 / AI3 / PID / INT1 / INT2
AI1
DISP_LINE2
Display Line 2
AI2
DISP_LINE3
Display Line 3
AI3
ELECTRONIC_INFO ELECTRONIC_INFO ELECTRONIC_INFO ELECTRONIC_INFO
Electronic Information Electronic Information Electronic Information Electronic Information
R Information about ident number, electronic revision and
production date. For details see subelements.
-
IDENT_NUMBER
Ident Number
Actual ident number
ELECTRONIC_REV
Electronic Revision
Actual electronic revision
PRODUCTION_DATE
Production Date
Date of production
Parameter Parameter Parameter Parameter
Subelement Access Description and settings Initial Value
.book Page 20 Tuesday, January 18, 2011 3:40 PM