KROHNE IFC 300 Converter FOUNDATION FIELDBUS EN - Manual (Page 28)

4
OPERATION
28
IFC 300
www.krohne.com 02/2011 - 4001086501 - AD IFC 300 FF R02 en
Settling_Field R/W settling of field (Fct. C1.3.16) 0
Setting:
0: off / 1: on
Diagnosis_Value R/W diagnosis value (Fct. C1.3.17) 25
Setting:
21: linearity / 25: off / 28: flow profile / 31: electrode noise / 8:
terminal 2 DC / 9: terminal 3 DC
SENSOR_CAL_DATE SENSOR_CAL_DATE SENSOR_CAL_DATE SENSOR_CAL_DATE
Sensor Calibration Sensor Calibration Sensor Calibration Sensor Calibration
Date Date Date Date
R The date of the last measuring sensor calibration. -
SENSOR_SN SENSOR_SN SENSOR_SN SENSOR_SN
Sensor Serial number Sensor Serial number Sensor Serial number Sensor Serial number
R The serial number of the measuring sensor. -
SENSOR_TYPE SENSOR_TYPE SENSOR_TYPE SENSOR_TYPE
Sensor Type Sensor Type Sensor Type Sensor Type
R The type of measuring sensor. 102
Setting:
102 (= Electromagnetic)
TRANSDUCER_ TRANSDUCER_ TRANSDUCER_ TRANSDUCER_
DIRECTORY DIRECTORY DIRECTORY DIRECTORY
Transducer Directory Transducer Directory Transducer Directory Transducer Directory
R A directory that specifies the number and starting indices of
the transducers in the Transducer Block.
0
Setting:
0...65535
TRANSDUCER_ TRANSDUCER_ TRANSDUCER_ TRANSDUCER_
TYPE TYPE TYPE TYPE
Transducer Type Transducer Type Transducer Type Transducer Type
R Identifies the transducer type. This is included in all the 4
views as per definition given in the standard pressure
transducer block given by FF.
Other
XD_ERROR XD_ERROR XD_ERROR XD_ERROR
Transducer Error Transducer Error Transducer Error Transducer Error
R One of the transducer error codes defined in the FF
Transducer Specifications in "Block Alarm Subcodes".
0
Setting:
16: Unspecified error (An error has occurred that was not
identified.)
17: General error (An error has occurred that could not be
classified as one of the errors below.)
18: Calibration error (An error occurred during calibration of
the device or a calibration error has been detected during
operation of the device.)
19: Configuration error (An error occurred during
configuration of the device or a configuration error has been
detected during operation of the device.)
20: Electronics Failure (An electronic component has failed.)
21: Mechanical Failure (An mechanical component has failed.)
22: I/O Failure (An I/O failure has occurred.)
23: Data Integrity Error (Indicates that data stored within the
system may not longer be valid due to NVM checksum failure.
Data verify after write failure, etc.)
24: Software Error (The software has detected an error. This
could be caused by an improper interrupt service routine, an
arithmetic overflow, a watchdog timer, etc.)
25: Algorithm Error (The algorithm used in the Transducer
Block produced an error. This could be due to an overflow,
data reasonableness failure, etc.)
Parameter Parameter Parameter Parameter
Subelement Access Description and settings Initial Value
.book Page 28 Tuesday, January 18, 2011 3:40 PM