KROHNE IFC 300 Converter FOUNDATION FIELDBUS EN - Manual (Page 34)

4
OPERATION
34
IFC 300
www.krohne.com 02/2011 - 4001086501 - AD IFC 300 FF R02 en
OUT_SCALE OUT_SCALE OUT_SCALE OUT_SCALE
Output Scale Output Scale Output Scale Output Scale
R/W The high and low scale values, engineering units code and
number of digits to the right of the decimal point to be used in
displaying the OUT parameter and parameters which have the
same scaling as OUT.
-
EU_100
Engineering Unit
100
R/W The engineering unit value which represents the upper end of
range of the associated block parameter.
100.0
EU_0
Engineering Unit 0
R/W The engineering unit value which represents the lower end of
range of the associated block parameter.
0.0
Units Index R/W Setting:
All units are possible.
Uninitialized
Decimal Point R/W The number of digits to the right of the decimal point which
should be used by an interface device in displaying the
specified parameter.
0
PV PV PV PV
Process Value Process Value Process Value Process Value
R Either the primary analogue value for use in executing the
function or a process value associated with it.
-
Status Actual status
Value Actual value
PV_FTIME PV_FTIME PV_FTIME PV_FTIME
PV F Time PV F Time PV F Time PV F Time
(Process Value (Process Value (Process Value (Process Value
Filter Time Filter Time Filter Time Filter Time
Constant) Constant) Constant) Constant)
R/W Time constant of a single exponential filter for the PV, in
seconds.
0
Setting:
0.0…60.0
SIMULATE SIMULATE SIMULATE SIMULATE
Simulate Simulate Simulate Simulate
Mix Allows the transducer analogue input or output to the block to
be manually supplied when "Simulate" is enabled. When
simulation is disabled, the simulate value and status track the
actual value and status.
-
Simulate Status R/W Used for the transducer status when simulation is enabled. Bad: Non Specific:
Non Limited
Simulate Value R/W Used for the transducer value when simulation is enabled. 0
Setting:
-3.39 E38 … +3.39 E38, - INF, + INF
Transducer Status R Status of value supplied by transducer. -
Transducer Value R Current value supplied by transducer. -
Simulate
En/Disable
R/W The parameter "SW_Simulated" in RB Block must be enabled. Disabled
Setting:
Uninitialized / Disabled / Active
STATUS_OPTS STATUS_OPTS STATUS_OPTS STATUS_OPTS
Status Option Status Option Status Option Status Option
R/W Options which the user may select in the block processing of
status.
0
Setting:
Propagate Fault Forward / Uncertain if limited / BAD if
limited / Uncertain id Man mode
UPDATE_EVT UPDATE_EVT UPDATE_EVT UPDATE_EVT
Update Event Update Event Update Event Update Event
R This alert is generated by any change to the static data. -
Unacknowledged R A discrete enumeration which is set to "Unacknowledged"
when an alarm occurs, and set to "Acknowledged" by a write
from a human interface device or other entity which can
acknowledge that the alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
Parameter Parameter Parameter Parameter
Subelement Access Description and settings Initial Value
.book Page 34 Tuesday, January 18, 2011 3:40 PM