KANOMAX 3886 Handheld Particle Counter - Manual (Page 32)

25
6.4 Printout of stored data… <4.DATA>→<3.PRINT>
Put the optional Printer cable into the modular jack of GEO--α,
and connect other side of the cable with the Printer to print
the stored data.
1 START
The first tag number of the stored data
to be printed
2 END
The last tag number of the stored data
to be printed
△ ▽ key Adjust the value
SET key Move the cursor
START/STOP key Start printing of the stored data
PREV key Go back to DATA
Preparations
Printer (Option) ････････ Recommendatory Printer Model. DPU-201GS (SEIKO CO., LTD),
Signal cable (Model 3886-07: Option), Signal cable connect GEO-α with Printer
DIP Switch Setting
Switch Number Function GEO-α Setting Printer
SW1 Word length 8 bit ON
SW2 Parity bit None ON
SW3 Set parity Odd number ON
SW4∼6 Baud rate 9600 following table
Baud rate SW4 Setting SW5 Setting SW6 Setting
9600 OFF OFF ON
* When using DPU-H245, please use it with the manufacturers default setting.
Signal cable
GEO-α Printer
Pin number Signal name Pin number Signal name
1 TXD 3 DATA
6 GND 4 GND
5 CTS 8 BUSY
6 GND 5 GND
<>
When the measurement interval (INT) in REPEAT mode is set at 15 seconds or less, there is a possibility
of Buffer error when printing is executed during a measurement. To print during a measurement, please
set the measurement interval over 15 seconds.
Modular jack
Start printing
STORE 139
1. START 001
2. END 139