KANOMAX 3886 Handheld Particle Counter - Manual (Page 12)

5
3.2 Turning the power on
(1)
Make sure to remove the cap of air inlet
at the top of the instrument.
(2) Push POWER switch in the function
key. Initial display shows the mode and
setup data of previous measurement in
WAIT status (Set at SINGLE mode at
the time of delivery).
Please refer to Chapter 4 for the
customizing of measuring mode or
method.
(3) WAIT sign will change to READY after
10 seconds. Then, measurement can be
started by pushing the START key.
At the time of delivery, sampling time
is set at 1 minute, so the measurement
will be automatically stopped after 1 minute.
[ Explanation of initial screen ] Power on
After 10 sec.
[測定終了]
[Measuring finish]
SINGLE 15:25
WAIT 0.3 0.00E+0／cf
0.5 0.00E+0／cf
Status
Measuring mode
Number of counts or
concentration
Current time
Particle size (SMALL)
Particle size (LARGE)
SINGLE 003BP 15:25
READY
0.3 0.00E+0／cf
0.5 0.00E+0／cf
SINGLE 003BP 15:25
１:00 0.3 0.00E+0／cf
0.5 0.00E+0／cf
SINGLE 003BP 15:30
STOP 0.3 0.00E+0／cf
0.5 0.00E+0／cf
START/STOP key
(1) Remove the cap!
(2) Push POWER switch.
(3) START/STOP key