KANOMAX 3886 Handheld Particle Counter - Manual (Page 16)

9
4. Setting before Measurement
4.1 Selection of measuring mode
Power on
(1) Push POWER key to input the power supply.
Then PREV key.
(2) Push PREV key again to proceed to the setup screen
(3) Use △ ▽ key to move the cursor, and push SET key to select
the mode you need.
[1.REPEAT] [2.SINGLE]
(4) Push PREV key to go back to
the MODE screen.
[3.CONT] [4. CALC] [5. REMOTE]
SINGLE 0.3/0.5µm
STR：N BEEP：N PR:N
SAMPLE 01：00
NO
CONT 0.3/0.5µm
STR：N BEEP：N PR:N
REPEAT 0.3/0.5µm
STR：N BEEP：N PR:N
SAMPLE 01：00 2TIMES
INT 00：05：00 NO
REMOTE 0.3/0.5µm
BEEP：N
NO
ＰＲＥ V
△▽
SINGLE 0.3/0.5µm
STR:N BEEP：N PR：N
SAMPLE 01:00
NO
ＰＲＥ V
ＰＲＥ V
１．
REPEAT 4．CALC
2．SINGLE 5．REMOTE
3．CONT
SET
CALC 0.3/0.5µm
STR：N BEEP：N PR:N
SAMPLE 01：00 2TIMES
NO