KANOMAX 3886 Handheld Particle Counter - Manual (Page 18)

11
4.2 Setting the measuring condition
In the case of REPEAT mode (other mode even same）
Use the △ ▽ key to move the cursor, and push the SET key to
select the mode you require.
Name Explanation
① Measuring mode
Five kinds of REPEAT, SINGLE, CONT, CALC,
REMOTE
② Particle size Two kinds selection from 0.3, 0.5, 1.0, 3.0, 5.0µm
③ Data storage Y：data stored N：data not stored
④
Warning beep
sound
Y：beep sounded N：beep not sounded
⑤ Data printing
Y：data printed after the measurement
N：data not printed (refer to 6.4)
⑥ Sampling time 1 second∼99 minites59 seconds
⑦ Frequency 1∼99 times and continuous (CNT)
⑧ Interval １ second∼24 hours
⑨
Confirmation of
setup NO：not confirmed
OK：confirmed. Press SET key to shift measurement screen.
(1) For change setting, push SET key to move the cursor.
REPEAT 0.3／0.5µm
STR:Y BEEP:N PR:N
SAMPLE 10:00 30TIMES
INT 00:30:00 NO
① Measuring mode
② Particle size
③ Data storage ⑤ Data printing
⑥ Sampling time ⑦ Frequency
⑧ Interval ⑨ Confirmation of setup
④ Warning beep sound
１．
REPEAT 4．CALC
2．SINGLE 5．REMOTE
3．CONT
ＰＲＥ V
△▽
SET
ＳＥＴ
REPEAT 0.3/0.5µm
STR：N BEEP：N PR:N
SAMPLE 01：00 2TIMES
INT 00：05：00 NO
REPEAT 0.3/0.5µm
STR：N BEEP：N PR:N
SAMPLE 01：00 2TIMES
INT 00：05：00 NO
ＳＥＴ