In-Situ Con TROLL PRO Installation Manual (purchased after 10 May 2012) - Manual (Page 15)

15
Do not over tighten.
3. Inside the enclosure, place the lock nut, concave-side-down, over the threaded end
of the plug or dome connector and tighten with a flat-head screwdriver and mallet.
Tighten the lock nuts so that there is approximately 1 thread showing above the nut.
4. Screw the dome nut onto the threaded connector. Tighten it to “snug” and then turn it
an additional half turn.
Do not over tighten.
5. Thread sensor or electrical cables through the dome connectors for later wiring by a
qualified electrical technician. Tighten to approximately 15 in-lbs of torque.
Figure 3.13 Controller box hardware
Figure 3.14 Attached port plug (left) and attached dome connector (right)