GW Instek GPI-700A Series HSB-001-01/-02 User manual - Manual (Page 3)

SCANNER BOX HSB-001-1/2
USER MANUAL
v
The wire which is coloured Brown must be connected to the
terminal marked with the letter L or P or coloured Brown or
Red.
If in doubt, consult the instructions provided with the
equipment or contact the supplier.
This cable/appliance should be protected by a suitably rated
and approved HBC mains fuse: refer to the rating
information on the equipment and/or user instructions for
details. As a guide, cable of 0.75mm
2 should be protected by
a 3A or 5A fuse. Larger conductors would normally require
13A types, depending on the connection method used.
Any moulded mains connector that requires removal
/replacement must be destroyed by removal of any fuse &
fuse carrier and disposed of immediately, as a plug with
bared wires is hazardous if a engaged in live socket. Any
re-wiring must be carried out in accordance with the
information detailed on this label.
SCANNER BOX HSB-001-1/2
USER MANUAL
1
1. PRODUCT INTRODUCTION
The manual of HSB-001-1/2 Scanner describes the function of
interconnecting and operation with GPT/GPI-700A. The optional
HSB-001-1/2 Scanning system can be easily interconnected to
GPT/GPI-700A to enhance it’s testing capabilities. In order to
fully understand the operation procedure, it is suggested that you
shall also refer to the manual of the GPT/GPI-700A.
This switching matrix allows GPT/GPI-700A to direct high
voltage to any of eight individual output ports, that is an ideal
accessory for applications on multiple points of the same item
which need to be tested quickly and accurately. The Scanner is
also applicable when the high volume manufacturing calls for
multiple items testing to save setup time.