GW Instek GOM-802 Programming Manual - Manual (Page 20)

DC MILLI-OHM METER
PROGRAMMER MANUAL
⎯ 38 ⎯
:CALCulation:LIMit:NORMal
Examples:
:CALCulation:LIMit:NORMal? might return 10000 in the COMP mode.
:CALCulation:LIMit:NORMal 10000 sets the normal value at 10000.
:CALCulation:RELation:STATe
Function:
Returns or sets the REL mode on or off.
Syntax:
:CALCulation:RELation:STATe?
Return:
0/1
:CALCulation:RELation:STATe
can be o(off) or 1(on).
Examples:
:CALCulation:RELation:STATe? might return 1 in the REL mode.
:CALCulation:RELation:STATe 1 sets the REL mode.
:CALCulation:RELation:DATa
Function:
Returns or sets the reference value in the REL mode.
Syntax:
DC MILLI-OHM METER
PROGRAMMER MANUAL
⎯ 39 ⎯
:CALCulation:RELation:DATa?
Return:
:CALCulation:RELation: DATa
is in ohm unit.
Examples:
:CALCulation:RELation:DATa? might return “+1.0000E+0” to indicate
1 ohm.
:CALCulation:RELation:DATa 1.0000 sets 1.0000 ohm at the reference
standard value.
:CALCulation:PERCent:STATe
Function:
Returns or sets the percent mode on or off.
Syntax:
:CALCulation:PERCent?
Return:
0/1
:CALCulation: PERCent
can be o (off) or 1 (on).
Examples:
:CALCulation: PERCent? might return 1 in the percent mode.
:CALCulation: PERCent 1 sets the percent mode.