GW Instek GDS-3000 Series DS3-SBD Serial Bus decode - Manual (Page 25)

MEASUREMENT
25
To set to TTL levels (1.4V), press Set to
TTL.
To set to ECL levels (-1.3V), press Set
to ECL.
Include R/W in
address 1. Press Include R/W in address from
the bottom menu.
2. From the side menu select Yes or
No.
R/W in
Address Yes, No
Bus Display 1. Press Bus Display from the bottom
menu.
2. Choose to display Hex or Binary
data on screen.
Range Hex, Binary
Event Table 1. Press Event Table from the bottom
menu.
2. Press Event Table from the side
menu to turn the event table On or
Off.
Event On, Off
3. To save the event table, press Save
Event Table.