GW Instek GDS-3000 Series DS3-SBD Serial Bus decode - Manual (Page 18)

GDS-3000 Serial Decode User Manual
18
Trigger On -
Address If Address was configured for the Trigger On
setting, then the triggering address/addresses
must be configured.
1. If Trigger On was configured to
Address or Address/Data (I 2 C), press
Address on the bottom menu.
2. Press Addressing Mode to toggle
between 7 and 10 bit addressing
modes.
3. To choose a preset address as the
default address, press Choose
Preset.
Address Description
0000 000 0 General Call
0000 000 1 START Byte
0000 1XX X Hs-mode
1010 XXX X EEPROM
0000 001 X CBUS
4. Press Apply Preset to set the default
address to the preset.
Note  Presets are not available for Trigger On
Address/Data.
5. Press Address from the side menu
to manually edit the triggering
address.
To edit the address, use the