List of available control codes – Fire-Lite PRN-6 Reference-Manual User Manual
Page 34
List of available
control codes
The IBM Proprinter X/XL and Epson FX850/1050 emulations only apply to the
9-needle printer version, whereas the IBM Proprinter X24/XL24 and Epson
LQ850+/1050+ emulations only apply to the 24-needle versions.
In the following table the available sequences in the various emulations are
marked with the symbol
✔
. MTPL sequences can be used in any of the emula-
tion modes. For this reason they are marked with an asterisk (*) in these emu-
lations.
✔
✔
✔
✔
✔
Acoustic alarm
✔
✔
✔
✔
✔
Backspace
✔
✔
✔
✔
✔
Cancel
✔
✔
✔
✔
✔
print the following 16 characters max. in
transparent mode (
✔
*
*
*
*
*
right justification and centering OFF
✔
*
*
*
*
*
emphasized mode ON
✔
*
*
*
*
*
emphasized mode ON
✔
*
*
*
*
*
MTPL command set
✔
*
*
*
*
*
end of command interpretations
✔
*
*
*
*
*
start of Barcode interpretation
✔
*
*
*
*
*
MTPL + IBM-Proprinter command set
✔
*
*
*
*
*
MTPL + IBM-Proprinter-24 command set
✔
*
*
*
*
*
MTPL + EPSON FX command set
✔
*
*
*
*
*
load character set with 256 characters
✔
*
*
*
*
*
load 2 character sets with 94 character
✔
*
*
*
*
*
Set "Proportional not in Draft“
✔
*
*
*
*
*
Reset "Proportional not in Draft“
✔
*
*
*
*
*
"Ignore print quality“ ON
✔
*
*
*
*
*
"Ignore print quality“ OFF
✔
*
*
*
*
*
MTPL + EPSON LQ command set
✔
*
*
*
*
*
at lineoverflow CR + LF
✔
*
*
*
*
*
at lineoverflow data are lost
✔
*
*
*
*
*
clear top and bottom margin
IBM
IBM
Epson
Epson
IBM-
MTPL
Propr.
Propr.
FX850
LQ850+
AGM
Code
Function
X/XL
X24XL24 FX1050
LQ1050+
2
4
List of available control codes
2 - 5
BACK
QUIT
?