Fire-Lite PS-Tools 5UD/10UD - Manual (Page 39)

30 5/10 Zone Panel
PS-Tools 07/2010
Configuring 5/10 Zones Fire Panel
Service Terminal
The ring count is the value which denotes the number of rings after which the connection is
established between the fire panel and central station.
To configure the Ring Count
1. Click Next at the lower right corner of the Secondary Central Station Continued pane or
click Service Terminal in the left pane.
2. Set the Ring Count to a value other than zero.
Figure 5-6 Configuring Service Terminal
3. Click Next to proceed with the configuration of ANN-BUS or click ANN-BUS in the left
pane.
Configuring ANN-BUS
ANN-BUS is a communication terminal in the fire panel over which different ANN devices can be
installed to communicate with the FACP. The ANN devices such as ANN-S/PG Printer Interface
module, ANN-IO LED Driver module, ANN-80 LCD Annunciator module, ANN-RLY Relay
module, and other types can be installed in the fire alarm system. You can configure the ANN-BUS,
when any ANN devices are installed.
To configure the ANN-BUS
1. Click Next at the lower-right corner of the Secondary Event Codes pane to view the
ANN-BUS pane or click ANN-BUS in the left pane.