Edwards Signaling WBR - Manual (Page 2)

Wall Mount - Surface Conduit/Wiring (Figure 2)
1. Use the backplate as a template to mark the positions of the
four mounting screws on the mounting surface.
2. Drill the four mounting holes at the positions described in 1
(above). Drill size should be determined by the size of the
mounting anchors and mounting screws (not supplied)
selected. Use oval head screws for mounting.
3. Remove the 1/2" (13 mm) knockout in the bottom of the
bracket. For indoor applications, install a 1/2" (13 mm) set
screw connector and locknut as shown in Detail A of Figure 1.
For outdoor applications, use appropriate conduit hardware.
A pull box may be used to simplify installation.
WARNING
Do not make power connections within the bracket.
4. Referring to instructions supplied with the AdaptaBeacon,
assemble bracket and secure AdaptaBeacon, routing field
ground and power wiring and making ground and power
wiring connections appropriately.
The external nipple protruding from the bracket arm is for
securing the AdaptaBeacon. A ground terminal is provided
for securing ground to the bracket in back of the bracket arm.
Two 1/4-20 x 1 1/4" (32 mm) screws are provided to mount
bracket arm to the backplate.
NOTE: If the Edwards AdaptaBeacon includes a 3/4" (19mm)
NPT conduit entrance, assemble the 3/4" - 1/2" (19-13
mm) reducing bushing to the external threaded nipple
protruding from the bracket arm.
5. Turn on the power to verify that the signal operates properly.
Wall Mount - Concealed Conduit/Wiring (Figure 3)
1. Mount the backplate to the installed standard 4" (102 mm)
square or 4" (102 mm) octagonal electrical outlet box with
oval head screws.
2. Mount the bracket to the backplate with the two 1/4-20 x 1 1/
4" (32 mm) screws provided.
3. Referring to instructions supplied with the AdaptaBeacon,
assemble bracket and secure AdaptaBeacon, routing field
ground and power wiring and making ground and power
wiring connections appropriately.
The external threaded nipple protruding from the bracket arm
is for securing the AdaptaBeacon. A ground terminal is
provided for securing ground to the bracket in back of the
bracket arm. Two 1/4-20 x 1 1/4" (32 mm) screws are provided
to mount bracket arm to the backplate.
NOTE: If the Edwards AdaptaBeacon includes a 3/4" (19 mm)
NPT conduit entrance, assemble the 3/4" - 1/2" (19 mm
- 13 mm) reducing bushing to the external threaded
nipple protruding from the bracket arm.
WARNING
Do not make power connections within the bracket.
Backplate
Mounting
Screws
See Detail A
1/2" Conduit and
Connectors (by others)
Pull Box (by others
if required)
Make Connections
in Base of
AdaptaBeacon
Gasket
Figure 2. Wall Mount Bracket Surface Wiring
Backplate
Mounting
Screws
Make Connections
in Base of
AdaptaBeacon
Gasket
Wallbox and Screws
(by others)
Wall Bracket
Assembly
Figure 3. Wall Mount Bracket Concealed Wiring
PP46000-1268 ISSUE 3
4. Turn on the power to verify that the signal operates properly.