Edwards Signaling 869DSTR-G1 - Manual

P/N 3100285 ISSUE 1 © 2001
Installation Instructions for 869DSTR*-G1 Series
Diode Polarized Electronic Horn/Strobe Signal Appliance
Description
The horn/strobes are UL and cUL Listed, high quality, diode
polarized signals intended for use in general signaling
applications. The strobes flash at 1 fps across their full
operating voltage range.
It is recommended that these products be installed in
accordance with the requirements in the latest edition of
national and local electrical codes.
See Tables 1 and 2 for specifications.
CHESHIRE, CT 203-699-3300 FAX 203-699-3365 (CUST. SERV.) 203-699-3078 (TECH SERV.)
WARNINGS
To reduce the risk of shock, always disconnect all power
before handling the unit.
To reduce the risk of shock, do not tamper with this device
when the signal circuit is energized. Disconnect all power
and wait 5 minutes for stored energy to dissipate before
handling.
Installation
Figure 1. Detailed View
1. Select mounting method as detailed in Figure 1 and
install the electrical box (not supplied) using suitable
hardware.
a. For outdoor applications, install the weatherproof
box (ordered separately) using four #10 x 1 1/4"
(32 mm) screws and cap lugs provided in the
enclosed parts bag.
NOTE: Be sure hook flange is facing outward as shown
in Figure 1.
NOTE: The designation "TOP" on boxes denotes
orientation of box after installation.
2. Attach mounting plate using two #8-32 screws
provided with the surface box (ordered separately) or
four #8-32 screws provided with the weatherproof box
(ordered separately). The flush box uses two #8-32
screws (not provided).
Table 1. Electronic Horn/Strobes
Catalog
Description Number
Horn/Strobe, Gray, Flush or Panel Mount 869DSTR*-G1
Indoor
*Insert lens color: C - Clear, R - Red, G - Green, B - Blue or A -
Amber