Warning – Edwards Signaling 125XBRi Chameleon User Manual

Page 3

P/N 3101611 ISSUE 3

WARNING

To avoid risk of injury, install lens before

energizing the unit.

WARNING

To prevent electrical shock, disconnect power

before removing the lens.

1. Thread the 18" (457 mm) signal wire leads through either

1/2" or 3/4" conduit into an approved conduit outlet box.

(Product is supplied with a double threaded - 1/2" internal

and 3/4" external - conduit hub.)

2. Thread the conduit onto the base of the signal.

Conduit Mounting (Figure 3)

Panel Mounting (Figure 4)
Note: When panel mounting these beacons, the surface

and construction details of the panel must be

taken into consideration in order to ensure that the

integrity of the outdoor, NEMA 4X rating is fully

maintained. Installer should evaluate.

1. Place the mounting gasket (supplied) over the hole in

the panel and route the signal wires through the gasket

and the hole in the panel.

2. Insert the base through the hole in the panel and screw

the locking nut (supplied), with the raised locking edge

facing the mounting surface, onto the base to secure

the beacon.

Figure 3. Conduit Mounting (3/4" Shown)

Figure 4. Panel Mounting

125XBRI Series Chameleon

LED Visual Indicator

3/4" (19 mm) NPT

conduit (not supplied)

Power source wires

Wire Nuts

(not supplied)

(Amber LED activation)

DC Units; Amber Positive (+)

AC Units; Amber Hot

(Red LED activation)

DC Units; Red Positive (+)

AC Units; Red Hot

DC Units; Black DC common (-)

AC Units; White AC neutral

(Blue or Green LED activation)

DC Units; Blue with green stripe, Positive (+)

AC Units; Blue with Green stripe, Hot

125XBRI Series Chameleon

LED Visual Indicator

Gasket

(supplied)

Wire nuts

(not supplied)

Locking Nut -

1.3625" OD

(supplied)

Control panel