Doric Instruments 5000D Digital Process Indicator and Miniature Datalogger - Manual (Page 7)

6
Single Channel Wiring
For easy installation, remove the pluggable terminal block
located at the rear of the unit. Connect the input power and
RS232 wires to the wire entry locations beneath and
perpendicular to the plug-in direction according to figure
below.
WARNING!
Dangerous voltages are exposed at the screw
terminals. Always remove power before working in
this area for rewiring, disassembly, and all other
activities that involve proximity to electrical
circuitry.
1 2 3 4 5 6 7 8 9 10
RTD - I
-V +V
RTD + I
SERIAL RXD SERIAL TXD SERIAL COM GND NEUTRAL 100/240VAC HOT