Doric Instruments 5000D Digital Process Indicator and Miniature Datalogger - Manual (Page 15)

14
are set to unlatch manually (‘MAN'), relay #1 may be
unlatched by pressing and holding the ARROW key while
pressing the PGM key. Pressing and holding the ARROW
key while pressing ENT key will unlatch relay #2.
Note: Basic units shipped from the factory are configured
for type K thermocouple,
°°F, 0.1 degree resolution.
Multiple Input models are shipped from the factory with a
5 second scan rate, channel 1 on, all alarms off with the
setpoint set LOW at 0000.
Dual Alarm/Analog Output models are shipped with both
alarms off, set for LOW and 0000. Deviation value set to
0000. Analog out is set to scale from 0
°° to 1000° ° with
either 0-10VDC or 4-20Ma out.
Sensor Setup
Example: To select Type K thermocouple,
°
F, and 0.1
°
resolution...
STEP 1.
Press the PGM button. PGM will appear on the
display. The
°
F/
°
C LED will change to P (for ‘Program
Mode).
STEP 2.
Press the Arrow key until INPT appears on the
display. Open the Input Menu for programming by pressing
the ENT key. One of the seven thermocouple types and two
RTD types will appear on the display (J,K,E,T,R,S,392,385).