Detcon DM-700 - Manual (Page 24)

Model DM-700
DM-700 Instruction Manual Rev. 4.0 Page 20 of 48
Gas Type
The menu item appears as: “ Gas Type = H2S”
Range of Detection
The menu item appears as: “Range XXX ppm”
Serial ID address.
The menu item appears as: “Serial ID XX”
AutoSpan Level.
The menu item appears as: “AutoSpan at XX ppm”
Days Since Last AutoSpan.
The menu items appears as: “Last Cal XX days”
Remaining Sensor Life
The menu item appears as: “Sensor Life 100%”
mA Output
The menu item appears as: “mA Output XX.XX”
Input Voltage Supply
The menu item appears as: “Voltage XX.X VDC”
Sensor Temperature
The menu item appears as: “Operating Temp XX C”
Output
The menu item appears as: “Output X”
Bias Voltage
The menu item appears as: “Bias Voltage XXXmV”
Gain Setting
The menu item appears as: “Gain Setting XX”
Raw Counts
The menu item appears as: “Raw Counts XXXX”
When the status list sequence is complete, the ITM will revert to the “View Sensor Status” text scroll. The
user can either: 1) review list again by executing another 3-4 second hold, 2) move to another menu item by
executing a momentary hold over PGM1 or PGM2, or 3) return to Normal Operation via automatic timeout of
about 15 seconds (the display will scroll “View Sensor Status” 4 times and then return to Normal Operation).