Avigilon Gallagher Command Center 7 Integration - Manual (Page 7)

Avigilon Control Center 5 System Integration Guide with Gallagher Command Centre
3
Installation
Server
1. Install the Gallagher Command Centre Server software.
2. Install the Gallagher Controller API (FTCAPI) on the Gallagher Command
Centre Server.
a. Set the Gallagher Controller IP port. Refer to the “API Location” topic in the
Gallagher Controller API Developers Guide .
b. Verify that FTCAPI is installed correctly by running the FTCAPI test
harness. It should start with no errors.
3. Install the Avigilon Gallagher integration software ( AvigilonGallagher7.exe ).
4. Apply the Avigilon integration license to one of the Avigilon Control Center 5
Servers in your system.
As you configure the integration, all references to the Avigilon server needs to
point to this server.
Client Computer
Complete the following steps for all Gallagher Workstations that require the Avigilon
Gallagher integration.
1. Install the Gallagher Command Centre Workstation software.
2. Install the Avigilon Gallagher integration software ( AvigilonGallagher7.exe ).
Checking the Licence
After you have installed all the required software, you can check if the ACC5-GLGR-CMNDC
licence has been properly applied:
NOTE: If you have a multi-server Site, only one server needs to have the integration
license.
1. Open the Avigilon Control Center Admin Tool.
2. Select the Settings tab and click Licensing. The License Activation dialog box
appears.
The dialog box must say Integration Connections: Yes or the software was not
properly licensed.