Star Water Systems SJ10 - Manual (Page 8)

8
95 North Oak Street • Kendallville, IN 46755 • © 2014 Star Water Systems. All rights reserved.
Well TO pUMp CONNeCTiON (SUCTiON pipe)
4
IL1535
Approx.
12 in.
Well Seal
4. Remove the pipe clamp and slide a well seal
(not included) over the PVC pipe and onto
the well casing. The PVC pipe should extend
approximately 12 in. above the top of the well
seal, depending on the height of the pump.
NOTE: Do not let the assembly slide down into the
well. Tighten the well seal until the rubber gaskets
are tight against the well casing and the PVC pipe.
5
1 in. PVC
Elbow
5. Using a 2-step PVC system, attach a 1 in. PVC
elbow (not included) onto the rigid PVC pipe
extending from the well seal.
7a
1-1/4 in.
opening
1 in.
opening
6. IMPORTaNT: Use short venturi tube in ejector
body for shallow well applications. Do not use
long venturi tube. Ejector must be attached to
front of pump for shallow well applications.
7a. Place gasket against back of ejector so that
openings in gasket line up with openings
in ejector. Line up bolts, 3/8 Lw and flat
washers with openings in ejector and slide
the bolts through the bolt opening.
6
IL1634
Short
Long