Spectra Precision Survey Pro v3.80 Recon GPS User Manual - Manual (Page 39)

RTK Data Collection
35
Note: If this receiver has already set an antenna with Survey Pro,
the measurement and settings will be recalled from the registry, so
you will not have to do this step again.
3. Tap
6(75RYHU to configure the receiver and begin receiving RTK
base information over the radio link.
Note: If you have post processing data collection turned on, the
receiver will now open a file (with the next available default name),
start recording GPS raw data, and enter the antenna information for
this setup.
4. You will return to the Survey menu when this is complete.
GET Base Position from Radio Link
a. Tap
6HWXS +5 to select your antenna type and measure the slant
or vertical height of the antenna.
b. Tap
*(7IURP %DVH to configure the receiver and begin receiving
RTK base information over the radio link.
c. Note: If you have post processing data collection turned on, the
receiver will now open a file (with the next available default
name), start recording GPS raw data, and enter the antenna
information for this setup.
d. Once the base station location is received over the radio link, you
are prompted to set the base reference position is Survey Pro. If
the base coordinate already exists in your job file, then that point
is chosen by Survey Pro as the base point. If the coordinate is new
to the job file, then you are prompted to give this new point a
name and Survey Pro will create the new base point.
e. The Base Setup wizard opens with the chosen Base Point name
displayed.