Spectra Precision Survey Pro v3.80 Recon GPS User Manual - Manual (Page 35)

RTK Data Collection
31
$XWR 'HWHFW. If this is not the correct baud, then select the correct
baud and tap 5HFHLYHU 6HW.
16. Communications is now set. Tap
2.
Format for RTK Corrections
17. Select your Format for RTK Corrections from one of the choices in
the combo box.
Receiver to Radio Communications
18. Select the type of radio modem you are using.
19. Make sure the baud; parity; and port is correct for the radio. On
the Base/Rover Radio card, verify the settings. If settings are not
correct, tap
&RQILJXUH 6HULDO and set the correct values.
20. Depending on your modem type selected, you may be able to
configure certain parameters of the modem using Survey Pro.
Tap the
&RQILJXUH 0RGHP button to open the Radio Settings
screen.
General Settings
21. Set the elevation cutoff. On the General card, select the elevation
cutoff to be used when you configure the receiver.
22. Set any other parameters specific to your brand and model. On
the General card, different receiver brands have special settings
available.
23. Hardware configuration is complete. Tap
2. twice to return to
the Base Setup screen.
RTK Configurations
Note: The following step is only necessary if you need to use
different COM port settings for your base and rover RTK receivers.
24. Set the base or rover configuration. If this receiver is the RTK
base, tap
6DYH FXUUHQW UHFHLYHU DV 57. %DVH. If this receiver is the