Spectra Precision Survey Pro v3.80 Recon GPS User Manual - Manual (Page 36)

GPS User’s Manual
32
RTK rover, tap 6DYH FXUUHQW FRQILJXUDWLRQ DV 57. 5RYHU. This will
automatically set the switch to Auto Connect RTK with saved
configuration . When you tap 6HW %DVH or 6HW 5RYHU from the RTK
Survey menu, the correct COM port and settings will be set
automatically.
Base Station Receiver Setup
Use the Base Setup screen to configure a GPS receiver to be an RTK
base station and to set the base reference position in Survey Pro.
1. Tap %DVH 6HWXS on the Survey menu to open the Current GPS
Base screen where information about the current setup is
displayed. Tap
6HWXS… to start the Base Setup wizard.
Pick the Base Point
2. Tap 6HWXS +5 to select your antenna type and measure the slant
or vertical height of the antenna.
Note: If this receiver has already set an antenna with Survey Pro,
the measurement and settings will be recalled from the registry, so
you will not have to do this step again.
3. Enter a name for the Base Point . You can select an existing point
from the job or you can enter a new point name for the job. If you
select:
•
An existing point with geodetic coordinates, we send these
reference coordinates to the GPS receiver and configure the
base coordinate in Survey Pro.
•
An existing point with plane only (N,E,Elev) coordinates, we
calculate geodetic coordinates from the current projection,
then send this reference position to the GPS receiver and
configure the base coordinate in Survey Pro.