Spectra Precision SP80 - Manual (Page 34)

English
28
Rover Setup
Network Rover A network rover needs to receive RTK corrections over the
Internet. This can be done in one of three ways:
• Using the built-in cell modem, which can be operated
after having inserted the SIM card purchased for this
purpose.
NOTE: Turn the SIM Card upside down (label facing
upward) before inserting it. Once the card has been
inserted, close the rubber flap.
WARNING - PLEASE, MAKE SURE YOU INSERT THE
SIM CARD INTO THE SIM CARD HOLDER AND NOT
ELSEWHERE.
Then you need to select this modem when configuring
your rover receiver for RTK operation (done from the field
software).
• Using the built-in WiFi device. You simply need to select
this device when configuring your rover receiver for RTK
operation (from the field software).
• Using the data collector’s internal cell phone. RTK
corrections are forwarded to the receiver over Bluetooth.
The picture shows a typical network rover setup using the T41
as the data collector.
Rover in CSD Mode Same as above using the built-in modem. The SIM card used
in that case is set to allow the rover to call the base directly
through a phone number.
Double-check with your ISP provider that CSD (or GSM data)
is available and activated in your subscription.
Rover With Radio See Using the UHF Kit Option on page 46.