LumaSense Technologies IGA 740-LO - Manual (Page 19)

15
6.2 Installation
6.2.1 Fix and connect the pyrometer
DANGER
There is danger of injury and possible equipment damage by connection
of cables under power!
Never connect cables under power! Make sure that the voltage supply is
switched off before connection of the cables to the pyrometer!
Install the pyrometer as follows:
1. Mount the pyrometer with the help of the retaining pin and taking into
mounting supports with available accessory (page 22).
2. Connect the coloured wires of the 5-pole connecting cable to
appropriate connections of a switchboard.
3. Connect the 5-pole connecting cable to the pyrometer at the back of
the instrument and to the power supply.
4. Double check stable set up of the pyrometer.
The pyrometer is ready for use and can be switched on.