LumaSense Technologies IGA 740-LO - Manual (Page 16)

12
5 Transport and Storage
5.1 Transport of the pyrometer
CAUTION
Environmental factors, impacts and the formation of water condensa
tion may damage some components!
CAUTION
When transporting the pyrometer, take suitable measures to protect all
components from environmental
factors, impacts and the formation of water condensation! Temporary
storage of the pyrometer in the open air is not permitted!
Prepare the pyrometer for transport as follows:
1. Switch the pyrometer off so that there is no tension and remove the connecting
cable and the signal cable
(e.g. protective cap, foil, …).
3. Pack the pyrometer in the original packaging paying attention to the means of
transport (see transport instructions below).
The pyrometer is thus ready to be shipped.
It is advisable to use the original packaging for the shipping of the pyrometer.
If the original packaging is no longer available, the pyrometer should be shipped
in a cardboard box with shock-absorbing PE material.
When transporting the pyrometer observe the following instructions:
through the effect of force, or careless loading or unloading.
severe temperature deviations while transporting.
should be inserted and the pyrometer should be sealed together with
the desiccator in a protective plastic sheet.
operation, then it should be carefully stored in a location protected
against dust and humidity (storage conditions - see section 5.2).