Configuring port settings, Configuring pppoe settings, 2 configuring port settings – LT Security IPPTZ762 User Manual

Page 47: 3 configuring pppoe settings

User Manual of IR Network Speed Dome

The router must support the route advertisement function if you select Route

Advertisement as the IPv6 mode.

6.3.2 Configuring Port Settings

Purpose:
If there is a router and you want to access the speed dome through Wide Area
Network (WAN), you need to forward the 3 ports for the speed dome.
Steps:
1. Enter the Port Settings interface:

Configuration > Basic Configuration > Network > Port
Or Configuration > Advanced Configuration > Network > Port

Figure 6-9 Port Settings

2. Set the HTTP port, RTSP port and port of the speed dome.

HTTP Port: The default port number is 80.
RTSP Port: The default port number is 554.
HTTPS Port: The default port number is 443.
SDK Port: The default port number is 8000.

3. Click

to save the settings.

6.3.3 Configuring PPPoE Settings

Purpose:
If you have no router but only a modem, you can use Point-to-Point Protocol over
Ethernet (PPPoE) function.
Steps:

This manual is related to the following products:

IPPTZ752