Hired-Hand Farm Hand Series: ST Temperature Controllers - Manual (Page 15)

4801-5043 Rev 7/00 Farm Hand ST 14
13. Calibrate Sensors
13.1 Calibration
1. The temperature sensors should be calibrated to ensure accurate temperature detection.
To calibrate the sensors an independent temperature measurement is required such as a
thermometer or thermocouple.
2.
Place a thermometer inside the house at the location of each sensor Allow a few minutes
for the temperature to stabilize.
3.
Take readings from the thermometers located at Sensor 1 and Sensor 2.
4.
Use the Program Mode to set calibrations of Sensor 1 and Sensor 2 (Refer to Table 3).