Hired-Hand System 1000 Power Curtain - Manual (Page 5)

System 1000 Power Curtain Controller Basics
••
2
Controller Basics
The front of the controller is known as the facepad. This is where all
operational commands are given, and current condition information is
received. There are ten pressure sensitive "buttons" on the facepad.
These "buttons" are the red colored arrows and rounded squares. To
operate the controller, press the square, or arrow desired. The functions
of the ten buttons are as follows:
Auto On -- Shifts the controller into automatic mode. Either ramped or
constant temperature mode are available with this option. Note:
Automatic Mode only refers to the action of the curtain machine.
Target Temperature Up or Down Arrows -- Used to raise or lower
target temperature while in automatic mode.
Close -- Used to close the curtains when in manual mode.
Off -- Used to stop curtain motion in manual mode, or to switch from
automatic to manual.
Open -- Used to open the curtains in manual mode.
Select Feature Up or Down Arrows -- Used to view selected features
while programming, also used to select features for alteration while
operating.
Change Setting Up or Down Arrows -- Used to adjust setpoints, turn
selected features on, or off, also to answer yes (up), or no (down) to
questions presented by the Controller during programming.