Hired-Hand System 1000 Power Curtain - Manual (Page 14)

System 1000 Power Curtain Initializing the Controller
••
11
Initializing the Controller
Initializing the controller means returning the controllers
programming to the original factory settings. If you are having trouble
with the controller and think it might be in the programming, you can re
initialize the controller by following this procedure.
Select
Feature
Change
Setting
Program Features
1. Cut power to the unit.
2. Re-apply power to the unit.
3. While the controller is starting up, the controller will darken all
segments of the screen. (The screen will look like several black
squares.) When this happens, press and hold down the Change
Setting up key with the Select Feature down key. Keep holding both
keys until the word "Init." appears, then release.
4. The controller will then be re-initialized and ready to operate in a
few seconds.
5. IMPORTANT!! Always "Zero out" the controller after initializing to
ensure that the power unit counters are accurate. If the counters are
not reading the right position, it could cause improper operation. To
Zero out the controller, press manual close and let the curtain fully
close. The controller will stop motion when the curtain is closed.
The controller will pause for about seven seconds while resetting.
You will need to reprogram the controller now, making sure that all
questions are answered accurately.