Elitegroup G736 - Manual (Page 98)

Upgrading your Memory
Refer to the following instructions and illustration for information on upgrading your
notebook's memory.
1. Turn off the computer and disconnect the AC adapter and all peripherals.
2. Turn the notebook over so that the rear ports are facing you and locate the memory
module compartment.
3. Remove the screws that secure the RAM module compartment cover. Remove the
compartment cover and then angling it up and out.
4. If you need to install a higher capacity module, gently push the edge clips on both
sides to release the module. Angle the card slightly upward and gently slide it from its
edge connector slot. Store the card in the anti-static bag that contains your new
module(s).
5. To install the new memory card, hold the card with its gold edge connector toward the
edge connector slot of the compartment. To help you orient the cards, the edge
connector has been made with two unequal-length sections. You will only be able to
insert the card in one direction.
6. Insert the edge connector into the slot. The gold edge connector of the card should not
96