Elitegroup G736 User Manual

Page 93

Solution

Make sure that the computer is not in Suspend mode. Check the Brightness controls

for the screen. If the controls are turned too far down, the screen will be dark.

Problem:

An incorrect date and time are displayed.

Correct the date and time using the DOS DATE and TIME commands or the options

in the Setup Utility. If the date and time become incorrect after a short time, your CMOS battery
may be depleted. Contact your dealer to change the battery.

The message: “Invalid system disk, Replace the disk, and then press

any key” appears during boot.

Check and make sure that you do not have a non-bootable floppy diskette inserted in

your floppy drive. If your USB FDD is empty, you may not have an operating system installed
on your drive. Contact technical support for assistance.

You hear irregular beeps during operation of the Notebook and the

system halts.

The problem is beyond the scope of this manual. Contact technical support.

An unidentified message is displayed.

Reboot the computer and run the BIOS system setup. Confirm the Setup parameters.

If the same message is displayed after booting up again, contact technical support for assistance.

The system cannot access the DVD-ROM drive.

Check that a CD is properly inserted in the drive. Make sure that you are using the

correct program for that kind of CD. For example, the system cannot read a data CD using an
audio program.

You cannot operate the printer.

Check the printer cable connection. Ensure that the printer power switch is turned on.

Confirm that the printer is on-line.