Elitegroup G736 - Manual (Page 53)

Inserting a PCMCIA Card
The computer will emit a medium tone followed by a high tone when a PC card is inserted.
When you eject a card, the computer will emit a high tone followed by a medium tone. You
can insert and remove a PC card whether the computer is turned On or Off.
Follow these instructions to insert a PCMCIA card:
1.
Hold the PCMCIA card with the arrow side up and the connector side toward the
socket.
2. Align the card connectors with the socket and carefully slide into the socket until it
locks into place. The system will beep once to indicate that it has detected the PC card.
To remove a PC card push the eject button, the button will pop out, push the button again to
eject the PCMCIA.
When inserting a Type II PC card, make sure the connector is
inserted in the socket. Before ejecting a PC card, ensure that
it is not being accessed by the System.
For example, if the message “Write protect error writing Drive
x” is displayed, the user has to change the write protect switch
setting on the memory card. To change the switch setting, (a)
eject the card, (b) change the switch setting, and (c) re-insert
the card.
Always disconnect all telephone lines from the wall outlet
before servicing or disassembling this equipment. To reduce
the risk of fire, use only No. 26 AWG or larger
telecommunication line cord.
51