Elitegroup G736 - Manual (Page 51)

Do not bend or drop the discs. •
Loading a Disc
To play a CD disc, follow the instructions listed below.
1.
Push the DVD-ROM/Combo eject button on the DVD-ROM drive door. Gently pull
the tray all the way out.
2. Carefully lift the CD disc by the edges and make sure the shiny surface is face down
(the side with no writing on it). Carefully insert the disc onto the tray. Push the CD
disc down gently so that it snaps onto the center ring.
3. Push the tray back into the drive.
To remove a disc, do the following:
1.
Check the LED display and make sure that the computer is not accessing the DVD-
ROM drive.
2. Push the eject button and pull the tray all the way out.
3. Carefully pick up the CD disk by the edges and – while pressing down on the center
ring – remove the CD disc from the tray.
Do not insert any foreign objects into the disc tray. If you
experience difficulty when ejecting the CD disc tray, stretch a
paper clip (or use a pin or a thin metal rod) and insert it into the
emergency eject hole located on the right side of the front
panel. The CD disc tray should eject immediately. This
procedure can also be used to remove a CD from the drive when
the Notebook is powered off.
49