Removing mac address entries, Displaying cpu usage, Changing the temperature polling interval – Brocade FastIron WS Hardware Installation Guide User Manual
Page 54
44
Brocade FastIron WS Hardware Installation Guide
53-1002498-02
Displaying CPU usage
4
Changing the temperature polling interval
The software reads the temperature sensor and polls other hardware sensors according to the
value set for the poll time, which is 60 seconds by default. You can change the poll time using the
CLI.
To change the poll time, enter a command such as the following at the global CONFIG level of the
CLI.
Brocade(config)#chassis poll-time 200
Syntax: chassis poll-time
The
Removing MAC address entries
You can remove the following learned MAC address entries from the system MAC address table:
•
All MAC address entries
•
All MAC address entries for a specified Ethernet port
•
All MAC address entries for a specified VLAN
•
A specified MAC address entry in all VLANs
For example, to remove entries for the MAC address 000d.cb80.00d in all VLANs, enter the
following command at the Privileged EXEC level of the CLI.
Brocade#clear mac-address 000d.cb80.00d0
Syntax: clear mac-address
If you enter the clear mac-address command without any parameters, the software removes all
MAC entries.
Use the
MAC address in the following format: HHHH.HHHH.HHHH.
Use the ethernet
Use the vlan
Displaying CPU usage
You can display the amount of the CHE1 CPU in use. To do so, enter the following command at any
level of the CLI.
Syntax: show cpu
Brocade#show cpu
31 percent busy, from 3248 sec ago
1 sec avg: 10 percent busy
5 sec avg: 10 percent busy
60 sec avg: 10 percent busy
300 sec avg: 10 percent busy