Brocade VDX 8770-4 Four-Post Flush and Recessed Mount Intake Air Duct Rack Kit Installation Procedure - Manual (Page 4)

4 of 24 Brocade VDX 8770-4 Four-Post Flush and Recessed Mount Intake Air Duct Rack Kit Installation Procedure
Publication Number: 53-1003114-02
Preparing to install the Intake Air Duct Kit in a four-post rack
Use the following instructions to install the Intake Air Duct Kit in a four-post rack.
There are two variations on the Intake Air Duct Kit depending on whether you need to have the port side of the
switch recessed or flush mounted. Instructions for the variations appear as follows.
• Installing the flush mount Intake Air Duct kit . . . . . . . . . . . . . . . . . . . . . . . . . 4
• Installing the recessed mount Intake Air Duct kit . . . . . . . . . . . . . . . . . . . . . 14
Time required
Allow approximately one hour to unpack and install the air duct kit in a rack.
Tools required
The following tools are required when installing the air duct kit:
• Torque wrench with #2 Phillips screwdriver tip
• Flathead screwdriver
Installing the flush mount Intake Air Duct kit
Unpack the Intake Air Duct Kit and check the contents against the parts list.
Parts list
See Figure 1 on page 5 for the parts list for the flush mount version.