Brocade VDX 8770-4 Four-Post Flush and Recessed Mount Intake Air Duct Rack Kit Installation Procedure - Manual (Page 23)

Brocade VDX 8770-4 Four-Post Flush and Recessed Mount Intake Air Duct Rack Kit Installation Procedure 23 of 24
Publication Number: 53-1003114-02
Install the air filter
If desired, install the air filter to the air intake grill using the five captive screws. Refer to Figure 18 .
FIGURE 18 Installation of the air filter (flush mount shown, recessed mount is similar)
Complete the following steps to mount the new front air filter on the air intake.
1. Orient the new filter over the five mounting holes using the screws as guides.
The mounting is asymmetric, so the holes match up only one way.
2. Using the #2 Phillips screwdriver, initiate the threads, two turns per screw, until all five are started.
3. Tighten all five screws, one at a time.
Do not overtighten the screws as this will compromise the frame, admitting unfiltered air.
Figure 19 on page 24 shows the chassis with the air filter installed.