Deleting an icx6650-10g-lic-pod license – Brocade FastIron Ethernet Switch Software Licensing Guide User Manual
Page 44
SSH and Secure Copy (SCP) must be enabled on the Brocade device before the procedures in
this section can be performed. To copy the file from an SCP-enabled client to the license
database of a specific unit, enter the following command. In the example, the license is copied to
unit 1.
scp license.xml [email protected]:license:1
Syntax: scp license_filename_on_host@IP_address:license:unit_id
The unit_id variable specifies a unit for which you want to add a software license file. The unit_id
variable is 1.
4.
Insert an SFP+ optical transceiver to enable ports to 10 GbE speed.
5.
Insert an SFP+ or SFP optical transceiver to enable the ports to 1 GbE speed.
6.
Repeat step 1 through step 3 above to enable ports 1/1/33 to 1/1/48.
7.
Repeat step 1 through step 3 above to enable ports 1/1/33 to 1/1/56.
By default, once the license is installed, the ports are up in 10 GbE port speed. You do not need
to use the speed-duplex command, or reload the system to enable the ports to 10 GbE port
speed. As you upgrade from a lower port to a higher port capacity license, the new license
replaces the previous license.
Deleting an ICX6650-10G-LIC-POD license
When downgrading to a lower port capacity license using the ICX6650-10G-LIC-POD license, you
must first delete the higher port capacity license and then re-install the lower port capacity license in
your system. A reload is required for the license to take effect.
1.
Delete the 16-port ICX6650-10G-LIC-POD license file from the device.
Brocade#license delete unit 1 index 1
2.
Use TFTP or SCP to copy the 8-port ICX6650-10G-LIC-POD license file to the license database
of the device. To use TFTP to copy the file to the license database of the Brocade device, enter
the following command.
Brocade# copy tftp license 10.120.54.185 lic.xml unit 1
Brocade#Flash Memory Write (8192 bytes per dot)
Copy Software License from TFTP to Flash Done.
copy tftp license [IP_address| ipv6_address] license_filename_on_host unit unit_id
The IP_address variable is the address of the IPv4 TFTP server.
The ipv6_address variable is the address of the IPv6 TFTP server.
The license_filename_on_host variable is the file name of the license file.
The unit unit_id variable specifies a unit for which you want to add a software license file. The
unit_id variable is 1.
If you attempt to download the same license twice on the device, the following error message is
displayed on the console.
Can't add the license string - 93 (DUPLICATE_LICENSE)
SSH and Secure Copy (SCP) must be enabled on the Brocade device before the procedures in
this section can be performed. To copy the file from an SCP-enabled client to the license
database of a specific unit, enter the following command. In the example, the license is copied to
unit 1.
scp license.xml [email protected]:license:1
scp license_file_on_host user@IP_address:license:unit id
The unit_id variable specifies a unit for which you want to add a software license file. The unit_id
variable is 1.
Deleting an ICX6650-10G-LIC-POD license
42
FastIron Ethernet Switch Software Licensing Guide
53-1003091-02