Snmp interface, User’s guide, Battery management system – APC Battery Management System User Manual
Page 19
®
USER’S GUIDE
Battery Management System
12
Telnet.
To access the Battery Management System’s control console using
Telnet:
1. Use the command telnet and the IP address of the Battery
Management System. For example:
telnet 170.215.6.49
2. Press the
E
NTER
key to open the Telnet session and display the
User
Name
prompt.
Logging on.
To log on to the control console, respond to the
User Name
and
Password
prompts. The default user name and password for the
Administrator account are both
apc
, all lowercase. You can change the user
name, password, and time-out values through the
System
menu.
SNMP interface
To use SNMP to configure the Management Card or to use the Battery
Management System traps for event notification, you must use version
3.6.9 (or later) of the APC PowerNet MIB.
See
.
See also
See the APC MIB Reference Guide
(.\doc\en\mibguide.pdf)
provided on the APC Battery Management System Utility
CD.