APC Battery Management System - Manual (Page 163)

®
USER’S GUIDE
Battery Management System
156
Run the Wizard to perform the configuration.
To discover and
configure, over the network, installed or embedded Network Management
Cards that are not configured:
1. From the Start menu, launch the Wizard. The Wizard automatically
detects the first Network Management Card that is not configured.
2. Select Remotely (over the network) , and click Next > .
3. Enter the TCP/IP settings ( System IP , Subnet Mask , and Default
Gateway ) for the unconfigured Network Management Card identified
by the MAC address at the top of the screen. Then click Next > .
4. On the Transmit Current Settings Remotely screen, if you check-
mark Start a Web browser when finished , the default Web browser
connects to the device that contains the Network Management Card
after you transmit the card’s settings.
5. Click Finish to transmit the TCP/IP settings. If the IP address you
entered is in use on the network, the Wizard prompts you to enter an IP
address that is not in use. Enter a correct IP address, and click
Finish .
6. The Wizard searches for another installed or embedded but
unconfigured Network Management Card. If it finds one, it displays the
screen with data entry boxes for the TCP/IP settings of that card.
– To skip configuring the card whose MAC address is currently
displayed, click Cancel .
– To configure the TCP/IP settings of the next card, repeat this
procedure beginning at step 3.