APC Battery Management System - Manual (Page 170)

®
USER’S GUIDE
Battery Management System
163
Use FTP or SCP to upgrade one Battery Management
System Management Card
For you to be able to use FTP to upgrade a single Battery Management
System over the network:
• The Battery Management System must be connected to the network.
• The FTP server must be enabled at the Battery Management System.
• The Battery Management System must have its TCP/IP settings
( System IP , Subnet Mask , and Default Gateway addresses)
configured.
To use FTP to upgrade the Management Card:
1. Open a command prompt window on a computer that is connected to
the network. Go to the directory that contains the firmware upgrade
files, and list the files. For the directory C:\apc, the commands would
be those shown in
bold :
C:\>
cd\apc
C:\apc>
dir
Files listed for a Battery Management System, for example, might be
the following:
– apc_hw02_aos_264.bin
– apc_hw02_app_260.bin
2. Open an FTP client session:
C:\apc>
ftp
If your APC device is running version 2.0.1 or later of the
AOS firmware already, you may upgrade directly to version
2.1.0 or a later version